What is Energy Conservation Code and why it is required?

What is the application of Nano Technology in the field of electricals?

What is the maximum life of earthing copper rods in earthing ground system?

Name some of the application of nanotech in field of power enggineering.

In an AC transmission line(3 phase), If there is a short between any two phases. How will you determine this fault on a protection relay. what will your wave forms look like?

When the operating wavelength of line is λ/4

Why we do not use pure capative load instead of pure inductive load?

What is the range of the stator resistance of 3 phase induction motor? To calculate losses for the motors with KW rating of 4, 7.5, 11, 15, 30, 37, 40, 45, 55, 90 etc. On which parameters it does depends on?

A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?

What is the range of the stator resistance of 3 phase induction motor?

One 3.5C cable is connected in a feeder with the neutral is isolated in the two ends(3 phases connected and neutral open in both sides). Now on rear end the output voltage is getting reduced by 20V in two phases and 40v increased by another phase.(between phase and neutral but neutral in open in two ends).the cable is meggered and we got the value of 100Mega ohm. There is no load in rear end. Kindly...

If the cables of co axial breaks down through connections then can it connect again...? give reason..

What is the purpose of track gauge used in transformers?

The circuit diagram is at http://avstop.com/AC/apgeneral/regulation.html

I cant completely figure out the way current is flowing through the three pole regulator that I have attached. I believe that current is coming up through the L1 coil into the positive terminal of the armature. and, I think current is flowing down through L2 coil and around back up to the positive terminal of the...

What is the standard size of a model of an electric tower for lab exhibition?

More or less what are the similarities and differences in paramagnetism and "Magnetic susceptibility".

Hello, I have two 12v DC wind generators that can provide charge to a 72v battery bank. This bank is used to power a 72Volt Electric Motor. I have one connected to the first battery (the positive connect for the entire bank) and the other generator is hooked up to the other or last battery of the 72v bank (the negative connect). Is this proper? Or, what do you recommend? Which manner should I best...